• tirsdag , 19 marts 2024

PDF: “MM92 acoustic report”, data fra uafhængigt målt infralyd, side 14

MM92_Windtest_report

Se rapportens side 14, hvor der vises, hvordan dB tallet stiger dramatisk ved infralyd på under 20 Hz. Kunne dette være hele hemmeligheden ved vindmøllernes skadelige virkning på mennesker og dyr?

 

Measurement of infrasound from a wind turbine

A physicist and acoustic engineer wrote to us:

REpower MM92 wind turbine
REpower MM92 turbine at Chemin d’Ablis, France

I do not believe that “amplitude modulation” is the real problem with wind turbine noise. I suspect that the wind industry do not believe it either, but are simply using it as a smokescreen to cover the real problem which is low frequency noise (in the 1 Hz to 20 Hz band, which covers the blade passing frequency and harmonics).

It is difficult to find reliable independent measured sound power data at frequencies below 20 Hz, but I have found some (attached), appended to a Canadian planning application, for a REpower MM92 – 2 MW wind turbine at Chemin d’Ablis, France.

Measured infrasound power data
The sound power level increases as the frequency decreases towards 2 Hz.

The plot on page 14 (above) shows how the sound power level increases as the frequency decreases towards 2 Hz; this is the lower frequency limit of the Norsonic 110 sound level meter used for the measurements. The blade passing frequency of the turbine is 0.75 Hz maximum.

Note that the usual plot on page 25 of the noise power level from 20 Hz upwards is, following standard practice, A-weighted. The sound power level at 20 Hz is the same on both plots, from which it follows that they are both A-weighted. Removal of the A-weighting would reveal very high sound power levels at the blade passing frequency and its harmonics.”

MM92 acoustic report

Relaterede indlæg

Skriv en kommentar